Wiring Guide

Using Netbell Ultra 300 with Viking MTG-10

How to wire a Netbell Ultra 300 output to a Viking MTG-10 multi-tone generator, so the Netbell schedule can play a tone over your paging system.

Updated October 30, 2026 2 min read Download PDF
How It Works

01How It Works

The Viking MTG-10 plays a tone when one of its tone-select pins is connected to pin 6. Its terminal strip is laid out like this:

MTG-10 pins Function
1–5 Tone select. DIP switches 1 and 2 choose which group of tones these pins play; see the Viking manual.
6 Common ground
7 and 8 Audio input (optional paging or music source)
9 and 10 Audio output, to the paging amplifier

Wire output OUT2 on the Netbell Ultra 300 across pins 1 and 6. Each time the Netbell schedule activates OUT2, its relay closes and the MTG-10 plays the tone assigned to pin 1.

02Wire the Ultra 300 to the MTG-10

  1. Turn off power to the Netbell Ultra 300 and the MTG-10.
  2. Connect MTG-10 pin 1 to the C (common) terminal of OUT2 on the Ultra 300.
  3. Connect MTG-10 pin 6 to the NO (normally open) terminal of OUT2. OUT2 is a dry contact, so these two wires can be swapped.
  4. Turn the power back on, then test by activating OUT2 from the Netbell web pages.
Tip

To trigger a second tone, wire OUT1 the same way between pin 6 and one of the other tone-select pins (2–5).

Figure 1Viking MTG-10 pins 1 and 6 wired to Netbell Ultra 300 OUT2

Still stuck? Our support team can help with setup and configuration.

support@linortek.com