Wiring Guide
Netbell-NTG and 70V PA System Wiring
How to connect a Netbell-NTG tone and message generator to a 70V mixer-amplifier and speakers, with one amplifier or two.
01Before You Start
The Netbell-NTG sends its tones and messages from its Line Out to the audio input of a mixer-amplifier. The amplifier drives 70V horn speakers. For larger systems, the first amplifier’s line out feeds a second amplifier.
| Setup | Use it when |
|---|---|
| One Netbell-NTG, one amplifier | One amplifier can power all your speakers. |
| One Netbell-NTG, two 240W amplifiers | You need more speakers than one amplifier can handle. |
Warning
With 30W speakers, connect a maximum of 6 speakers to each 240W amplifier. Connecting more than 6 will damage the amplifier. To add more speakers, contact Linortek support.
02One Netbell-NTG, One Amplifier
- Connect the Netbell-NTG Line Out (LFT, GND, RGT) to the mixer-amplifier’s AUX audio input with an RCA cable.
- Wire the speakers in parallel to the amplifier’s COM and 70V outputs.
- Optional: connect push buttons to the Netbell-NTG digital inputs DIN 1–DIN 4 (+ and −) to trigger tones or messages manually.
The diagram also shows the amplifier’s other connections:
| Amplifier connection | Use |
|---|---|
| MIC1 | Microphone input, for XLR or 1/4” phone plugs |
| TEL INPUT | Telephone paging input: ground, negative and positive |
| LINE OUT | Left/right RCA output, to send audio to a second amplifier if needed |
03One Netbell-NTG, Two 240W Amplifiers
- Connect the Netbell-NTG Line Out to the first mixer-amplifier’s AUX input with an RCA cord.
- Connect the first amplifier’s LINE OUT to the second amplifier’s AUX input with a male-to-male RCA cord.
- Wire up to six 30W speakers in parallel to each amplifier’s COM and 70V outputs.
Still stuck? Our support team can help with setup and configuration.
